Filter
Top Products
To operate one-touch up, pull the switch completely up to the second
detent and release quickly. The window will close fully. Momentarily
press the switch to any position to stop the window operation.
Global open windows
Press and hold
to begin opening the two front windows and venting
the panoramic roof (if equipped).
• The
control can then be released and the windows and panoramic
roof will complete the opening operation.
• If
or is pressed during the opening operation, both windows
and panoramic roof movement will stop.
Note: The ignition must be off and the accessory delay feature must be
not activated in order for this feature to operate.
Note: This feature can be disabled or enabled by your authorized dealer
or through the message center. Refer to Message center in the
Instrument Cluster chapter.
Bounce-back
When the window is moving upward and an obstacle or a rough road
condition interferes with the window’s movement, the window will
automatically reverse direction and move down. This is known as
“bounce-back”. If the ignition is turned off (without accessory delay
being active) during bounce-back, the window will move down until the
bounce-back position is reached.
Security override
To override a bounce-back condition, within two seconds after the
window reaches the bounce-back position, pull and hold the switch up
and the window will travel up with no bounce-back or pinch
protection. If the switch is released before the window is fully closed,
the window will stop. For example, this can be used to overcome the
resistance of ice on the window or seals.
Driver Controls
64
2011 MKX (mkx)
Owners Guide, 1st Printing
USA (fus)