Filter
Top Products
8
Misc. on the TECHLINE
TM
actuator system
Warranty
There is a 12 months’ warranty on the TECHLINE products against manufacturing
faults calculated from the production date of the individual products (see label).
LINAK’s warranty is only valid in so far as the equipment has been used and
maintained correctly and has not been tampered with. Furthermore, the actuator
must not be exposed to violent treatment. In the event of this, the warranty will be
ineffective/invalid. For further details, please see LINAK A/S ordinary conditions of
sale.
Maintenance
• The actuator must be cleaned at regular intervals to remove dust and dirt and
inspected for mechanical damages or wear.
• Inspect attachment points, wires, piston rod, cabinet, and plug, as well as check
that the actuator functions correctly.
•
The actuator is a closed unit and requires no internal maintenance.
•
To ensure that the pregreased inner tube remains lubricated, the actuator
must only be
washed down when the piston rod is fully retracted.
Maintenance of spherical eyes
In order to maintain a prober performance of the spherical eyes and to increase
the resistances against hard environmental wear, we strongly recommend that the
spherical (ball bearings) eyes mounted on actuators from LINAK are greased with
anticorrosive grease or similar.
Warning!
If irregularities are observed, the actuator must be replaced.