Filter
Top Products
16
Be aware of BUS actuator - please see the installation guide.
Accessories
Cables:
Power cables (Ordered separately) Order no.
1.5 m cable 0367002-1500
5 m 0367002-5000
0.2 m cable (AMP connectors) 0367006
Signal cable (Ordered separately) Order no.
1.5 m cable 0367003-1500
5 m 0367003-5000
Mounting of cables
• Unscrew the cover and remove the two blind plugs
• Plug in the power cable and/or the signal cable
• Slide the cover onto the actuator
The torque of the cover screw is +/- 0.3 Nm
TORX 25IP
Note: When changing the cables on a LINAK actuator, it is important that
this is done carefully, in order to protect the plugs and pins. Please be sure
that the plug is in the right location and fully pressed in before the cable lid
is mounted.