Filter
Top Products
15
Troubleshooting
Action
• Connect the actuator to the
power supply
• Change cable
• Send actuator for repair
• Align or reduce load
• Send actuator for repair
• Send actuator for repair
• Send actuator for repair
• Change cable
• Send actuator for repair
• Increase power supply
• Thicker cable
• Reduce load
Possible cause
• The actuator is not connected to
the power supply
• Cable damaged
• Misalignment or overload in
application
• Gearwheel or spindle
damaged
• Clutch is worn
• Motor is damaged
• Cable damaged
• Potentiometer damaged
• Insufficient power supply
• Voltage drop in cable
• Load is higher than specified
Symptom
No motor sound or
movement of piston rod
Excessive electricity
consumption
Motor runs but spindle does
not move
Actuator cannot lift full load
No signal from potentiometer
or hall effect sensor
Motor runs too slowly or
does not give full force
Actuator cannot hold the
chosen load
1 2 3 4 5 6 7 8 9 10 11 12
CS16-4-24
MAX MIN
P
HB40 serie
-
+
R = RED . O = ORANGE . GR = GREEN
R GR O
Connection of the LA35 with the CS16
Be aware of BUS actuator - please see the installation guide.