Filter
Top Products
6
206-4050-A
The RJP-101M can only be installed in a vertical position into the
backsplash of the cabinet. Vertical mounting in the back-
splash is required so that if liquid is spilled on the desk
top, it will not be able to flow into the RJP. The RJP must
only
be installed in the backsplash panel cutout opening.
It will then need to be secured with the four retainer clips, serrated
washers and machine screws provided. The cable wiring assembly and
individual cables will need to be connected to the RJP. All cables
will need to be threaded along the backside of the backsplash panel
through the TV wiring cutout to the TV and other in-room resources.
Note: The connector set that is closest to the mesh sleeving is for
hook up to the TV display panel.
Installation Instructions
1. Remove the cabinet backsplash and insert the RJP into the cutout
opening.
2. Install the four L-shaped mounting retainer clips, screws and
serrated washers provided to hold the RJP securely in place. Check
to assure that the RJP is securely mounted.
3. Make all connections to the RJP, please see the following page for
details.
4. After attaching cable hardware etc., reinstall backsplash on the
cabinet.
Installation in Cabinet Backsplash
(4-Screws)
.....
.....
CAUTION: The cable wiring assembly should be handled carefully to
avoid damage, as it is fed through the opening and
attached to the RJP. The cable assembly needs to be
looped down into the area provided and then threaded
along the channel in the backside of the backsplash to the
TV wiring cutout in the cabinet. The AC power cord should be plugged
into a dedicated and appropriate AC wall power outlet.
.....
.....
Note: The actual appearance of the
cable assembly, cabinet, backsplash,
mounting hardware and cable
clamps etc., may be different than
shown in these drawings.