Applying The Decals
The main decals have already been
applied to your Nitro 4-Tec. The extra
decals provided are die-cut for easy
removal. Use a hobby knife to lift the
corner of a decal and remove it from
the backing.
Carefully position the decal over the
desired location and press one side on
the body. Pull the decal tight and use
a finger to gradually smooth out any
air bubbles as you apply the decal.
Look at the photos on the box for
typical decal placement.
8
•
Nitro 4-Tec 3.3
Decorating Installing your Nitro 4-Tec 3.3 Body
Installing The Body Mounts
The body mount parts are located
in a separate bag with your
instructions. The front body mount
posts attach to the front bumper
with 3x10mm countersunk cap
screws. Slide the foam bumper
over the front mounts, as shown in
the drawing. The excess length of
the mounts should be trimmed off
after the body is installed.
The rear body mounts attach as
shown in the drawing.
Installing Front Body Mounts
3x10mm countersunk
cap screws
Foam
Bumper
3x14mm
buttonhead
cap screws
3x10mm countersunk
cap screws
Foam
Bumper
Installing Rear Body Mounts