Land Rover LR3 Automobile User Manual


 
Electric parking brake
12
13
On-road and off-road
Automatic transmission
With the gear selector in Sport, the
transmission will stay in lower gears for
longer with downshifts occurring more readily.
Fuel consumption will be adversely affected.
If Terrain Response is fitted, Sport mode is
only available if the General program is
selected.
Gearshift interlock
The starter switch must be in position II, the foot
brake applied and the selector release button
pressed before the gear selector can be moved
from P (Park) to R (Reverse).
The gear selector must be in the P position
before the starter key can be removed.
Sport mode
In Sport mode, automatic gear
changing is maintained but the
gearshift changes are modified to
improve performance.
To select Sport mode, move the
gear selector from the D (Drive)
position towards the left hand
side of the vehicle.
The word SPORT will appear on
the instrument pack display and the LED in the
gear selector surround will illuminate.
CommandShift ™
CommandShift gear selection can be used as an
alternative to automatic gear selection and is
particularly effective when rapid acceleration or
engine braking is required.
1. Select Sport mode. The transmission will
automatically select the gear most appropriate
to the vehicle’s road speed and accelerator
position.
2. Moving the selector lever forward (+) or
backward (-) and then releasing will manually
select a higher or lower gear (when available).
The message TRANSMISSION
COMMANDSHIFT SELECTED will appear in
the message centre.
3. Subsequent gear selections will display the
selected gear on the instrument pack display.
4. To deselect CommandShift mode, move the
selector lever back to the D position.
Applying
With the vehicle stationary, pull up the
parking brake lever and then release it. The
red warning indicator in the instrument pack
will illuminate.
Releasing
The starter switch must be in position I or II.
Apply the foot brake and press down on the
parking brake lever.
If the vehicle is stationary with the parkbrake
applied and either D (Drive) or R (Reverse)
selected, pressing the accelerator will
automatically release the parking brake.
P
R
N
D
M
S
+
-
M
S
P
R
N
D
M
S
+
-
Cruise control
Cruise control will automatically disengage
when the brake pedal is used or when the
vehicle speed falls below 18 mph.
Cruise control enables the driver to maintain a
constant road speed without using the accelerator
pedal.
1. SET +: to set a road speed or increase the
speed in 1 mph steps when cruise control is
operating.
2. SET -: to set a road speed or decrease the
speed in 1 mph steps when cruise control is
operating.
3. RESUME: resumes a SET speed retained in
memory.
4. CANCEL: cancel cruise control but retains
the set speed in memory.
1
2
3
4
Air suspension
Vehicle height will be automatically adjusted
according to road speed in order to maintain
driveability and handling.
Some of the Terrain Response programs will
automatically adjust the suspension height.
Vehicle height can be manually adjusted via the
raise/lower lever 1. Height changes may only be
made when the engine is running and the driver and
passenger doors are closed.
Indicators 2 or 7 will illuminate to show the direction
of movement. They extinguish when the height
change movement is completed.
Off-road height 3, provides improved ground
clearance and approach, departure and break-over
angles.
On-road height 4, is the normal height for the
vehicle.
Access height 5, lowers the vehicle to provide easier
entry, exit and loading of the vehicle. This position
may be selected up to 40 seconds after the starter
switch is turned off.
Crawl (locked at Access height) 6, allows the vehicle
to be driven at low speeds at access height, to give
increased roof clearance.
1
3
4
5
6
2
7