Filter
Top Products
3
11/23/05
Manual No. 701-075M
Land Pride
Assembly Instructions for 4200/4400 ST Trekers
■
Assembly Instructions for
4200/4400 ST Trekers
Engine Cold Weather Kit No. 701-074A
General Information
Be sure to read all instructions and safety precautions on
page 1 before installing the Engine Cold Weather Kit.
Installation Instructions
Refer to Figure 4:
1. Release retaining clips two places on bottom of air
cleaner canister and remove air cleaner access
cover.
Figure 4
Refer to Figure 5:
2. Loosen driver’s side canister bolt and rotate canister
until air intake tube is facing diagonally toward left
front corner of the engine.
Refer to Figure 6:
3. Install heat gathering shield over the engine exhaust
manifold at the 90 degree bend as shown.
4. Secure with muffler clamp, flat bar, and two nuts.
NOTE: It is not necessary to disconnect engine
snorkel.
21455
Engine
Snorkel Hose
Access Cover
Retaining Clip
AirCleaner
Canister
Engine
Snorkel
5. Obtain flexible aluminum tube and, taking care not to
deform it, expand the tube to approximately 14”.
Install one end on the heat gathering shield and the
other end on the canister air intake tube.
6. Secure in place with the stainless steel hose clamps
as illustrated.
7. Reinstall the lower access cover to the air intake
canister.
8. Tighten driver’s side canister bolt.
Figure 5
Figure 6
Driver’s Side
Canister Bolt
214547
Air Intake Tube
Before Rotation
Flexible
Aluminum Tube
SSHose
Clamp
Air Filter
Intake Tube
Rotated
SS Hose
Clamp
Heat
Gathering
Shield
Muffler Clamp
Flat Bar
Engine Exhaust
Manifold
21453
Treker 4200/4400 ST Series Engine Cold Weather Kit Part No. 701-074A
1 701-075M MANUAL - ENGINE COLD WEATHER KIT
1 700-204H HEAT GATHERING SHIELD
1 700-267D MUFFLER CLAMP FLAT BAR
1 700-272D 2" FLEXIBLE ALUMINUM TUBE 18.0" LG
2 800-259C HOSE CLAMP WRM DRV#36SS (1.81-2.75)
Qty. Part No. Part Description