Filter
Top Products
4
Manual No. 701-075M 11/23/05
Land Pride
Assembly Instructions for 4200/4400 NT Trekers
■
Assembly Instructions for
4200/4400 NT Trekers
Engine Cold Weather Kit No. 701-073A
General Information
Be sure to read all instructions and safety precautions on
page 1 before installing the Engine Cold Weather Kit.
Installation Instructions
Refer to Figure 1:
1. Loosen the stainless steel Hose Clamps securing
the rubber air intake hose.
2. Remove rubber air intake hose and save for later
reinstallation when warmer weather prevails.
Refer to Figure 2 & Figure 3:
!
CAUTION!
Caution: Make sure the flexible aluminum tube does not come
into contact with battery terminals. If necessary, secure the
aluminum air intake tube safely away from the battery with a
plastic tie strap.
3. Install heat gathering shield over the engine exhaust
manifold at the 90 degree bend as shown.
4. Secure with muffler clamp, flat bar, and two nuts.
Figure 1
AirCleaner
Canister
Rubber Air
Intake Hose
21127
SS Hose
Clamp
5. Obtain flexible aluminum tube and, taking care not to
deform it, expand the tube to approximately 40”.
Install one end on the heat gathering shield and the
other end on the canister air intake tube.
6. Secure in place with the stainless steel hose clamps
as illustrated.
Figure 2
Figure 3
Flexible
Aluminum Tube
Muffler Clamp
Flat Bar
Engine Exhaust
Manifold
Heat
Gathering
Shield
SS Hose
Clamp
21457
Flexible
Aluminum Tube
SS Hose
Clamp
Battery
Terminals
AirCleaner
Canister
21456
Canister Air
Intake Tube
Treker 4200/4400 NT Series Engine Cold Weather Kit Part No. 701-073A
1 701-075M MANUAL - ENGINE COLD WEATHER KIT
1 700-204H HEAT GATHERING SHIELD
1 700-267D MUFFLER CLAMP FLAT BAR
1 700-271D 2" FLEXIBLE ALUMINUM TUBE 36.0" LG
2 800-259C HOSE CLAMP WRM DRV#36SS (1.81-2.75)
Qty. Part No. Part Description