Filter
Top Products
2
Manual No. 701-075M 11/23/05
Land Pride
Assembly Instructions for 4210/4410 ST Trekers
■
Assembly Instructions for
4210/4410 ST Trekers
Engine Cold Weather Kit No. 701-074A
General Information
Be sure to read all instructions and safety precautions on
page 1 before installing the Engine Cold Weather Kit.
Installation Instructions
Refer to Figure 7:
1. Loosen the two stainless steel hose clamps securing
the air intake hose.
2. Remove air intake hose and save for later
reinstallation when warmer weather prevails.
Figure 7
Refer to Figure 7:
3. Install heat gathering shield over the engine exhaust
manifold at the 90 degree bend as shown.
4. Secure with muffler clamp, flat bar, and two nuts.
Figure 8
23804
Air Intake
Hose
SS Hose
Clamp
SS Hose
Clamp
Heat
Gathering
Shield
Muffler Clamp
Flat Bar
Engine Exhaust
Manifold
23805
Refer to Figure 9:
5. Obtain flexible aluminum tube and, taking care not to
deform it, expand the tube to approximately 14”.
Install one end on the canister air intake tube as
shown.
6. Secure in place with the stainless steel hose clamp.
Figure 9
Refer to Figure 10:
7. Install the other end on the heat gathering shield as
shown.
8. Secure in place with the stainless steel hose clamp.
Figure 10
23806
Flexible
Aluminum Tube
SS Hose
Clamp
AirCleaner
Canister
23807
Flexible
Aluminum Tube
SS Hose
Clamp
Heat Gathering Shield
Treker 4210/4410 ST Series Engine Cold Weather Kit Part No. 701-074A
1 701-075M MANUAL - ENGINE COLD WEATHER KIT
1 700-204H HEAT GATHERING SHIELD
1 700-267D MUFFLER CLAMP FLAT BAR
1 700-272D 2" FLEXIBLE ALUMINUM TUBE 18.0" LG
2 800-259C HOSE CLAMP WRM DRV#36SS (1.81-2.75)
Qty. Part No. Part Description