Filter
Top Products
Clutch lever
The clutch lever [1] is fitted on the left hand side of the handle bar. The adjusting screw [A]
is used to change the original position of the clutch lever (see maintenance work on
chassis and engine).
The clutch is hydraulically actuated and adjusts itself automatically.
Choke lever
If the choke lever [2] is pulled backwards, a bore in the carburetors will be opened in the
carburetor through which the engine may draw in additional fuel. This produces a „rich“
fuel/air mixture necessary for cold start. The fuel quantity and thus the engine speed are
determined by the choke lever position.
At temperatures over 5°C (41°F) it will suffice to pull the choke lever half way out. At tem-
peratures below 5°C (41°F) the choke lever should be pulled all the way out. The hole is
closed again by pushing the choke lever all the way back in.
Hand brake lever
The hand brake lever [3] is mounted on the right side of the handlebar. The adjusting screw
[B] can be used to change the basic position of the hand brake lever (see Maintenance).
OPERATION INSTRUMENTS »
7
3
2
A
1
B