Filter
Top Products
MAINTENANCE WORK ON CHASSIS AND ENGINE 80
200112-10
ದ Place a suitable container under the engine.
ದ Remove engine oil plug screenb
.
ದ Completely drain the engine oil.
ದ Thoroughly clean the plug and gear oil screen.
ದ Clean the sealing area on the engine.
ದ Check parts for damage and wear. Replace damaged or worn parts.
ದ Fit plugb
for the engine oil screen and tighten it.
Specification
Plug, engine oil screen M17x1,5 20bNm
(14.8blbfbft)
Removing the oil filterb
x
Warning
Danger of scaldingಘEngine oil and gear oil get very hot when the motocycle is driven.
ದ Wear suitable protective clothing and gloves. If you scald yourself, hold the affected area under cold water immediately.
Warning
Environmental hazardಘProblem materials cause environmental damage.
ದ Dispose of oil, grease, filters, fuel, cleaning substances, brake fluid, batteries, etc. according to regulations.
ದ Place a suitable container under the engine.
200113-10
ದ Remove screwsb. Remove oil filter coverb with O-ring.
200114-10
ದ Pull the oil filter insertb out of the oil filter casing.
Circlip pliers reverse (51012011000)
ದ Completely drain the engine oil.
ದ Thoroughly clean parts and sealing area.
Mounting oil filterb
x
200114-11
ದ Check parts for damage and wear. Replace damaged or worn parts.
ದ Lay the motorcycle on its side and fill the oil filter housing to about 1/3 full with
engine oil.
ದ Fill the oil filterb
with engine oil and place it in the oil filter container.
ದ Lubricate the O/ringb
of the oil filter cover.