KTM 450 XCR-W USA Motorcycle User Manual


 
OPERATING ELEMENTS 16
Querying lap time
Info
This function can be called only if lap times are measured.
Condition
The motorcycle is standing.
400321-01
Press the buttonb briefly and repeatedly until LAP appears at the bottom right of
the display.
Press the buttonb briefly.
The LAPb1 is displayed on the left of the display.
Laps 1-10 can be displayed by pressing the buttonb"+".
buttonb"" no function
Press the buttonb briefly.
next display mode
Info
If an impulse is received from the wheel speed sensor, the left side of the
display changes back to SPEED mode.
Display mode SPEED
400317-02
Press the buttonb briefly and repeatedly until SPEED appears on the left of the
display.
In the SPEED display mode, the current speed is displayed.
The current speed can be displayed in Km/h or in Mph.
Info
Making the setting according to the country.
When an impulse comes from the front wheel, the left side of the speedometer
display changes to the SPEED mode and the current speed is shown.
Display mode SPEED/H (service hours)
400316-01
Condition
The motorcycle is standing
Press the buttonb briefly and repeatedly until H appears at the bottom right of the
display.
In display mode H, the service hours of the engine are displayed.
The service hour counter stores the total traveling time.
Info
The service hour counter is necessary for ensuring that maintenance work is car-
ried out at the right intervals.
If the speedometer is in H display mode at the start of the journey, it automati-
cally changes to the ODO display mode.
The H display mode is suppressed during the journey.
Press the buttonb"+". No function
Press the buttonb"". No function
Press the buttonb
for 3 - 5 seconds.
The display changes to the Setup menu of the speedometer
functions.
Press the buttonb
briefly.
Next display mode