Filter
Top Products
ENGLISH
32
MAINTENANCE WORK ON CHASSIS AND ENGINE »
Cooling system
Coolant is circulated by a water pump [1] located in the engine.
Air blowing in through the radiators cools the coolant. The slower the speed
of the motorcycle, the less the coolant is cooled down. Dirty
radiators also reduce the cooling efficiency.
Pressure induced by heating of the coolant in the system is controlled by a
valve in the radiator cap [2]; a water temperature rising up to 120° C
(248° F) is admissible, without fear of problems.
– If possible, always check level of cooling liquid when the engine is cold.
If you have to open the radiator cap when the engine is hot, use a rag to
cover the cap and open slowly to release pressure. Caution - scalding hazard.
– Do not detach any radiator hoses while the engine is hot. The escaping
hot coolant and the steam may cause serious burns.
– In case you get burnt, hold the affected part of your body under running
cold water right away.
– Coolant is toxic. Keep the coolant out of the reach of children.
– In case coolant is ingested, consult a doctor immediately.
– If coolant gets into your eyes, rinse them out with water immediately and
consult doctor.
A mixture of 50% antifreeze liquid and 50% destilled water is used as coolant.
However, the antifreeze protection must be at least -25° C (-13° F). This mixture
offers antifreeze protection but also good corrosion protection and should therefore
not be replaced by pure water.
– The cooling system must be bled after draining the cooling liquid or after
adding more than 0.25 l (0.06 US gallons) cooling liquid.(see below).
– For the cooling system, use only high-grade antifreeze (e.g. Motorex Anti
Freeze). Using lower-grade antifreeze agents can cause corrosion and
coolant foaming.
Checking the coolant level
The coolant should be 10 mm (0.4 in) above the radiator fins when the engine
is cold (see diagram). In the event of the coolant being drained, always fill
and bleed the system.
If possible, always check the level of cooling liquid when the engine is cold.
If you have to open the radiator cap [2] when the engine is hot, use a rag to
cover the cap and open slowly to release pressure.
Bleeding the cooling system
By removing the screw [3] at the water pump cover you can drain the coolant.
To bleed the cooling system, add coolant up to approx. 10 mm above the radiator
fins when the engine is cold.
After a short ride, check the coolant level once more.
when engine ist cold
10 mm
1
1
450 SX-F250 SX-F
450 SX-F250 SX-F
3
3
2