KTM 1190 RC8 JP Motorcycle User Manual


 
IMPORTANT NOTES 9
You will find the currentKTMPowerParts for your vehicle on the KTM website.
International KTM Website: http://www.ktm.com
Work rules
During assembly, non-reusable parts (e.g. self-locking screws and nuts, seals and seal rings, O-rings, pins, lock washers) must be replaced
by new parts.
If a thread lock (e.g.Loctite
®
) is used for screw connections, be sure to comply with the manufacturer's specific advice on its usage.
Parts that you want to reuse following repairs and servicing should be cleaned and checked for damage and wear. Change damaged or
worn parts.
Following servicing, the vehicle must be checked for roadworthiness.
Transport
Note
Danger of damageDanger of damage by the vehicle running away or falling over.
Always place the vehicle on a firm and even surface.
Note
Fire hazardSome components (engine, radiator and exhaust system) get very hot when the engine is running.
Do not place the vehicle where there are flammable or explosive substances.
Switch off the engine and remove the ignition key.
Secure the motorcycle against falling over or running away using straps or other suitable devices.
Environment
Motorcycling is a wonderful sport and we naturally hope that you can enjoy it to the full. However, it can also lead to problems with the
environment and conflict with other persons. Responsible behavior in handling the motorcycle can help to avoid such problems and con-
flicts. To ensure the future of motorcycle sport, make sure you use the motorcycle legally, demonstrate a consciousness for the environ-
ment, and respect the rights of others.