Filter
Top Products
9.13
Section 9
Disassembly
9
Figure 9-48. Removing No. 1 Side Intake Manifold
Screws with the Ground Leads.
3. Disconnect the wire leads from the Oil Sentry
™
and safety interlock switch, temperature
sensor, and/or warning alarm, as equipped.
See Figures 9-49 and 9-50.
2. Remove the two No. 1 side intake manifold
mounting screws securing the ground leads and
clip for the wiring harness. Note the locations of
the clip and ground leads. See Figure 9-48.
Figure 9-49. Temperature Sensor.
Figure 9-50. Warning Alarm.
4. Lift the by-pass hose, with the wiring harness
attached, and work the ends of the harness back
through the openings in the lower blower housing
to remove. See Figure 9-51.
Figure 9-51. Removing By-pass Hose and Wiring
Harness.