Filter
Top Products
11.24
Section 11
Reassembly
Install Ignition Modules and Flywheel
1. Route the spark plug leads of the ignition
modules, out through the corresponding cutouts
in the lower blower housing assembly.
2. Route the white kill leads from the wiring harness
and connect them to the ‘‘kill’’ tabs of the ignition
modules. See Figures 11-82 and 11-83.
Figure 11-82. Ignition Module Kill Lead Mounting
#2 Side.
Figure 11-83. Ignition Module Kill Lead Mounting
#1 Side.
3. Position the modules on top of the mounting
bosses. Slide the ignition modules as far away
from the crankshaft as possible. See Figure
11-84. Do not attempt to attach the modules
onto the mounting bosses at this time.
Figure 11-84. Ignition Modules ‘‘Back’’ as Far as
Possible.
Install the Flywheel
Warning: Damaging Crankshaft and
Flywheel Can Cause Personal Injury!
Using improper procedures to install the Flywheel can
crack or damage the crankshaft and/or flywheel. This
not only causes extensive engine damage, but can
also cause personal injury, since broken fragments
could be thrown from the engine. Always observe and
use the following precautions and procedures when
installing the flywheel.
NOTE: Before installing the flywheel make sure the
crankshaft taper and flywheel hub are clean,
dry, and completely free of lubricants. The
presence of lubricants can cause the flywheel
to be overstressed and damaged when the
hex. flange screw is torqued to specifications.
NOTE: Always use a flywheel strap wrench or holding
tool to hold the flywheel when tightening the
flywheel fastener. Do not use any type of bar
or wedge to hold the flywheel, as component
damage and personal injury could result.
1. Install the woodruff key into the keyway of the
crankshaft. Make sure that the key is properly
seated and parallel with the shaft.
NOTE: Make sure the flywheel key is installed
properly in the keyway. The flywheel can
become cracked or damaged if the key
is improperly installed.
2. Thread two or three long bolts into the hub of the
flywheel, or use the flywheel puller, to serve as a
‘‘handle’’ for setting the flywheel in place.