Kenwood KCA-BT200 GPS Receiver User Manual


 
18
|
KCA-BT200
Operation of hands-free phoning (Model-E)
Hands-Free Control screen
Or when a call
comes in …
TEL
Hands-Free Control screen
Hands Free
P1
P2
P3
SetUp
1
23
4
56
7
8
0
9
#
*+
KENWOOD
0123456789
Clear
Return
AUTO
11
12
14
8
9
10
15
1
2
3
13
5
6
7
4
Control screen
NextNext
DVD VIDEO
13:50
IN
TEL
Title 1 Chap 3 T0:05:20
KENWOOD
SCRL
TIMEREP
16
1 Displays the Search for Phone Book screen.
(See the <Calling a number in the Phone Book>,
page 20)
2 Displays the Out Going Calls screen.
(See the <Calling a number in the call log>, page
20)
3 Displays the Incoming Calls screen.
(See the <Calling a number in the call log>, page
20)
4 Switches between the private and hands-free
modes (only when a call in progress).
5 Displays the Hands-Free Set Up screen.
(See the <Setting up the Hands-Free Phone>, page
20)
6 Enter three phone numbers for quick dialing.
(See the <Speed dialing>, page 20)
7 Enters a phone number.
(See the <Dial a number>, page 20)
8 Displays the signal strength.*
The more the number of bar segments, the
stronger the signal.
9 Displays the present Auto Answering status
When Auto Answering is on:
AUT
O
When Auto Answering is off:
p Displays the battery drain of the cell-phone.*
The more the number of bar segments, the higher
the battery level.
q Starts the call.
w Ends the call.
Clears the phone number being entered.
e Clears the entered phone number.
r Returns to the previous screen.
t Displays the calling and called phone numbers.
If you have registered a phone number in the
Phone Book, the destination person name is
displayed.
y Displays the status of connection with the cell-
phone.
White: The cell-phone is connected.
Orange: The cell-phone is not connected, or it is
outside the service range.
• While your car is moving, some functions are
disabled for safety’s sake. The buttons associated
with the disabled functions become ineffective if
pressed.
• When the Hands-Free Control screen appears, the
name of the connected cell-phone is displayed for 5
seconds.
• Setting the cell-phone in the private mode can
disable the hands-free function.
• * Since the number of steps of the control unit is
different from that of the cell-phone, the statuses
displayed on the control unit may discord from
those displayed on the cell-phone. No status
Before Use
• You need to register your cell-phone before using
it with this unit. For more details, see <Registering
Bluetooth device> (page 12).
• If you have registered two or more cell-phones, you
need to select one of them. For more details, see
<Selecting a Hands-Free Phone> (page 21).
• To use the Phone Book, it must be downloaded to
this unit in advance. For details, see <Downloading
the Phone Book> (page 13).