Kenwood DNX4250DAB GPS Receiver User Manual


 
8686
Return to the Top page
Setting Up
Touch panel adjustment
1 Touch [Touch] in the System Menu
screen.
Touch Panel Adjustment screen appears.
2 Follow the instruction on the screen
and touch the center of each .
NOTE
• To cancel the touch panel adjustment, touch
[Cancel].
• To reset to the initial status, touch [Reset].
Security setup
You can set up a security code to protect
your receiver system against theft.
NOTE
• When the Security Code function is activated, the
code cannot be changed and the function cannot
be released. Note the Security Code can be set as
the 4 digit number of your choice.
1 Touch [Security] in the System Menu
screen.
Security screen appears.
2 Touch [ON] of [SI].
NOTE
• DNX7250DAB, DNX5250BT, DNX525DAB
If “SI” is turned on, the SI indicator on the front
panel flashes when the panel is detached. Default
is “ON”.
• DNX4250DAB, DNX4250BT
If “SI” is turned on, the SI indicator on the front
panel flashes when the vehicle ignition is off.
Default is “ON”.
3 Touch [SET] of [Security Code Set].
NOTE
• If you have already completed the code
registration, [CLR] is displayed.
4 Enter a security code with four-digit
number and touch [Enter].
5 Enter the same code again and touch
[Enter].
Security code is registered.