Filter
Top Products
INSTALLATION & OWNER’S MANUAL
Rev. G
p. 1 of 9
CAB INSTALLATION INSTRUCTIONS
KAWASAKI MULE 600 SERIES
HARD AND/OR SOFT SIDED CAB KIT (p/n KAF600-012)
(Note: hard sided doors, soft sided doors, and anti-draft panel are
sold separately but are included in these instructions.)
The contents of this envelope are the property of the owner.
Be sure to leave with the owner when installation is complete.
This cab is shown with the following optional equipment: hard sided doors, work lights,
windshield wiper, strobe light, and antenna for overhead console. Other options not
shown are: soft sided doors and an anti-draft panel for underneath the bench seat.
RECOMMENDATIONS:
1) It is recommended that the tire pressure be adjusted as follows when installing a cab
on this vehicle: front tires to have 11.5 p.s.i. and rear tires to have 18.0 p.s.i.
2) It is recommended that two (2) heavy-duty springs (p/n 92145-0400) be used in the
rear
suspension when installing a cab on this vehicle. It is also recommended to set
the spring adjusting sleeve of the rear
shock unit at the circled position in the chart
below (position 4).