Filter
Top Products
J8472a-0920
11
• Fit the front clip onto the front of the vehicle, as shown.
Hint: The front clip may already be on the vehicle.
Front Clip
FRONT VIEW
13
• “Snap” a hubcap onto the center of each wheel cover.
• Turn the vehicle upright.
12
• Slide a
7
/16" washer onto the front axle.
• Slide a bushing, ring end first, onto the front axle.
• Locate a wheel marked L. Slide the wheel, flat side first, onto the
front axle.
• Slide a wheel cover, indented side out, onto the front axle.
• Slide another
7
/16" washer on the front axle.
Front Axle
10
Cotter Pin
11
Washer
Bushing
(Ring End First)
Wheel (L)
(Flat Side First)
Washer
Wheel Cover
(Indented Side Out)
Front Axle
Hubcaps
Hubcaps
SIDE VIEW
BOTTOM VIEW
• Fit a cotter pin into the hole near one end of the rear axle.
IMPORTANT! Do not force the cotter pin past the third bend.
When correctly assembled to the axle, it should look like the inset
illustration above.
• Repeat steps 10 and 11 to assemble the remaining washers,
bushing, wheel, wheel cover and cotter pin to the other front axle.
Third Bend