Filter
Top Products
J8472a-0920
10
Plate
• While holding the handlebar in place, carefully turn the vehicle over.
• Again, make sure the end of the steering column is through the hole
in the steering linkage.
• Fit the steering column cap onto the end of the steering column.
• Insert a #8 x
3
/4" screw through the large opening in the steering
column cap and into the hole in the steering column. Tighten
the screw.
8
9
• Slide the plate under the steering column, as shown.
• Insert a #8 x
3
/4" into the plate and tighten.
6
7
• Lift the front end of the vehicle up slightly. Check to be sure the
steering column fits through the hole in the steering linkage. Lower
the front end of the vehicle.
• Push down on the handlebar assembly to “snap” it in place.
BOTTOM VIEW
Steering Column
Connectors
Steering Column Cap
Steering Column
BACK VIEW
• Turn the vehicle upright.
• Fit the handlebar steering column and both connectors down
through the large opening in the front end of the vehicle.