Filter
Top Products
J5248pr-0920
9
• While holding the handlebar in place, carefully turn the vehicle over.
• Make sure the end of the steering column is through the hole in the
steering linkage.
• Fit the steering column cap onto the end of the steering column.
• Insert a #8 x
3
/4" screw through the large opening in the steering
column cap and into the hole in the steering column.
Tighten the screw.
Steering Column Cap
Steering Column
Opening
• Fit a
3
/16" washer onto the #8 x 2" screws.
• Insert the screws with washer into the base plate plate and tighten.
• Turn the vehicle upright.
8
BACK VIEW
9
• Insert the handlebar steering column down through the opening
in the front end of the vehicle. Be sure to fit the steering column
through the opening in the base plate and the hole in the steering
linkage (underneath the vehicle).
• Push to “snap” the handlebar into the vehicle.
BOTTOM VIEW
BOTTOM VIEW
BOTTOM VIEW
10
• Slide the clip (open side down) under the end of the steering
column, as shown.
Clip
11