Kawasaki J5248 Offroad Vehicle User Manual


 
J5248pr-0920
7
Children can be harmed by small parts,
sharp edges and sharp points in the vehicle's
unassembled state, or by electrical items.
Care should be taken in unpacking and
assembly of the vehicle. Children should
not handle parts, including the battery,
or help in assembly of the vehicle.
WARNING
• Turn the vehicle upside down.
• Fit the front end to the vehicle. Make sure the sides of the front
end wrap around the vehicle. You may need to check this for
assembly steps 2 -5.
• Plug the charger connector into the battery
A
.
• Plug the charger into a standard wall outlet
B
.
Notes:
- Use the charger only in a wall outlet. Do not plug the AC adaptor
into a ceiling outlet.
- If power flow to the wall outlet is controlled by a switch, make
sure the switch is “ON”.
• Before first-time use, charge the battery for at least 18 hours.
Never charge the battery longer than 30 hours.
• Recharge the battery for at least 14 hours after each use of your
vehicle. Do not charge the battery longer than 30 hours.
• Once the battery is charged, disconnect the charger connector from
the battery. Unplug the charger from the wall outlet. The battery is
now ready to be installed in your vehicle. Please see the Battery
Installation section on page 11 for detailed instructions on installing
your battery. If your battery is already installed in your vehicle, simply
re-connect the motor harness connector to the battery.
Battery
Charger
Connector
FRONT VIEW
1
Front End
ASSEMBLY
A
B
Vehicle
• Fit a #8 x
3
/4" screw through the hole shown in the front end and
into the vehicle. Tighten the screw.
2
BOTTOM VIEW
#8 x
3
/4" Screw