Filter
Top Products
J5248pr-0920
8
• Position the base plate with the ribbed side facing out.
• Fit the narrow end of the base plate under the steering linkage
and into the slot in the front end.
Base Plate
• Fit another #8 x
3
/4" screw through the hole shown in the front end
and into the vehicle. Tighten the screw.
Hint: You may need to adjust the front end to align the holes.
3
• Grasp the bar on the front end and pull it out and up to properly
position the front end.
4
6
7
• Now, fit eight more #8 x
3
/4" screws into the remaining holes in the
front end and tighten them.
Hint: You will need to turn each wheel (one at a time) to fit all of
the screws.
5
Bar
Front End Slot
Steering Linkage
• Insert two #8 x
3
/4" screws though the front end and into the base
plate. Tighten the screws.
#8 x
3
/4" Screw