Filter
Top Products
9
2
1
Battery
Compartment
Dash
•Position the dash on the vehicle body.
• Make sure the motor harness connector wire is through
the groove in the dash.
•Insert a #10 x
1
/
2" screw through each of the two corner
dash tabs nearest to the passenger compartment .
•Insert a #10 x 1" screw through the two dash tabs
nearest to the battery compartment .
•Insert a #10 x 1" screw into the hole in the center of the
dash, near the battery retainer clip .
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
Battery Clamp
Assembly
Battery
Clamp Unit
•Insert two #10 x 1" screws through the holes in the
battery clamp unit and into the pegs in the dash.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
Motor
Harness
Connector
Wire
2
3
• Before applying the labels, wipe the surface of the
vehicle with a clean, dry cloth to remove any dust or oils.
• Place the labels exactly as shown in the illustrations.
•For best results, avoid repositioning a label once it has
been applied to the vehicle.
13
14
15
4
HI LO KC
21
23
16
Labels - Dash
17
12