Filter
Top Products
•Fit the sport bar into the holes in the vehicle body.
• Push down firmly on a sport bar support while pulling
up on the side fender to fit the sport bar into the
vehicle body.
• Repeat this procedure on the other side of the
vehicle body.
Sport Bar Support
Side
Fender
PULL
HERE
PUSH
HERE
23
15
Assembly
Taillight
Housing
Taillight
Lens
#8 x 1" Screws
•Turn the vehicle upright.
• Using safety scissors, remove the taillight lenses and the
taillight housings from the plastic connectors. Dispose of
the plastic connectors.
•Face the rear of the vehicle.
• Fit a taillight lens inside a taillight housing.
•Position the taillight housing with lens against the vehicle
body with the screw holes aligned, as shown.
•Insert two #8 x 1" screws through the taillight lens and
housing and into the vehicle body as shown.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
• Repeat this procedure to attach the other taillight.
•Position the cap so that its tether points down.
• Snap the cap into the hole under the right taillight.
Cap
Tether
•Turn the vehicle on its side.
• Insert two #10 x
1
/
2
"
screws into the holes in the
underside of each rear wheel well, through the vehicle
body and into the ends of the sport bar.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
Rear of
Vehicle
24
25
26
Bottom View