Filter
Top Products
13
•Turn the seat upside down.
•Insert the fastener end of a short seat belt strap through
the slot near the outer edge of the seat. Make sure the
side of the seat belt with the fastener faces the outer
edge of the seat.
• Pull the short seat belt strap completely through the slot
until the last T-loop at the opposite end of the belt catches
against the slot.You will pull one T-loop through the slot.
• Repeat this procedure to assemble the other short seat
belt strap.
Short Seat
Belt Strap
Fastener End
Seat
Slot
End
T-Loops
Slot
T-Loop (Pull through slot)
Assembly
•Insert each fastener end of the long seat belt strap
through a slot in the center of the seat. Make sure the
fasteners face the outer edge of the seat.
• Pull each side of the long seat belt strap evenly through
the slots. Make sure to pull each T-loop through a slot.
•Turn the seat upright.
T-Loop
Fastener End
Long Seat Belt Strap
• With the seat at an angle, insert the tabs on the front
edge of the seat into the slots in the foot-well wall .
• Push down firmly on the edge of the seat above each
tab to snap the tabs into the slots .
• Rotate the back of the seat down to snap the seat
back tabs into the slots in the vehicle body. Push down
firmly on the seat back.
Seat
Tabs
Seat Back
Tabs
Slot
1
2
PUSH
HERE
17
18
19
Spacers
Brush Guard
Grille
16
• Fit two spacers between the grille and the
back of the brush guard, as shown.
•Insert two #8 x 4" screws through the brush
guard, the spacers and into the holes in
the grille.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.