Filter
Top Products
11
© 2005 Directed Electronics—all rights reserved
6. Exit and lock the vehicle.
Use the following procedure to
eexxiitt
Pit Stop Mode:
1. Enter the vehicle.
2. Place the key to ignition (not the crank or start position).
3. Step on the brake (this causes the system to exit Pit Stop
Mode).
4. Or press the button twice.
The doors will lock 3-seconds after the remote start shuts down
if ignition controlled locking is programmed on.
lleeaarrnniinngg ttrraannssmmiitttteerr
The system comes with one programmed transmitter. The
receiver can store up to 4 different transmitter codes in memory.
Additional transmitters (part no. 471T) can be ordered by
contacting your local dealer.
Use the following procedure to add a transmitter to the system.
1.
FFuusseess..
Remove both fuses from the control module fuse
holders then re-insert into main fuse holders.