Filter
Top Products
34
© 2004 directed electronics, inc.
unique melody (or vibrate) and the remote start icon (19) will
turn off when the remote start shuts down.
valet
®
take-over
The Valet
®
Take-Over feature allows the vehicle to remain
running after the key has been removed from the ignition. This
feature is useful for occasions when you wish to exit and lock the
vehicle for short periods of time, but would like to leave the
motor running and the climate controls on.
To perform Valet
®
Take-Over:
1. Before turning off the engine, press and release twice
within 3-seconds on the remote (or press and release the
optional momentary switch). Then wait five seconds. A
remote start page notification with a unique melody (or
vibration) will be generated and the LCD 2-way remote will
display the remote start icon (19) as long as the vehicle is
running. Then wait three seconds.
2. Turn the ignition key to the OFF position. (The engine will
stay running.)
3. The engine will run until the pre-programmed time elapses
or a shut-down input is received. (See the previous
Remote
Start
section for a complete list of shut-down inputs.)
note: This feature will not work if the brake pedal is
being pressed.
➜