Filter
Top Products
Assembly
17
• Loosen the screw in the sound box’s battery
compartment door using a Phillips screwdriver and open
the battery compartment.
• Insert three, size “AA” (LR6) alkaline batteries in the
sound box as indicated in the battery compartment.
• Close the battery compartment door and tighten the
screw using a Phillips screwdriver. Do not over-tighten.
(For longest life, use only alkaline batteries.)
Sound Box
Battery
Compartment
Battery
Compartment
Door
31
SHOWN ACTUAL SIZE
3 x 1.5V
“AA” (LR6)
TM
• Position the vehicle upright.
• Fit the tabs on the front fork cover into the rectangular
openings in the top of the front fork and push firmly
to snap the cover to the front fork.
Rectangular
Openings
Front Fork Cover
Tab
Tab
30
Battery Tips:
• Do not mix old and new batteries.
• Do not mix different types of batteries: alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium).
• Remove the batteries during long periods of non-use.
Always remove exhausted batteries from the sound box.
Battery leakage and corrosion can damage the vehicle.
• Never short circuit the battery terminals.
• Non-rechargeable batteries are not to be recharged.
• Only batteries of the same or equivalent type as
recommended in these instructions are to be used.
• If removable rechargeable batteries are used, they are
only to be charged under adult supervision.
• Rechargeable batteries are to be removed from the
sound box before they are charged.
• If you use a battery charger, it should be examined
regularly for damage to the cord, plug, enclosure and
other parts. Do not use a damaged battery charger until
it has been properly repaired.
• When sound from the vehicle becomes faint, or if the
sound stops working, it’s time to replace the batteries.
• Dispose of batteries safely.
Round
Bushing
• Fit a round bushing, plate side first, onto the axle.
Helpful Hint: You may need to push the shock outward
slightly to fit the round bushing.
• Continue to slide the axle through the shock.
• Fit a .437 (large diameter) retainer on the end of the axle.
• Support the opposite end of the axle and tap the retainer
with a hammer to secure it on the end of the axle.
• Pull on the .437 retainer to make sure the front wheel
assembly is secure.
Shock
.437 (Large
Diameter)
Retainer
Wheel
Axle
29