Filter
Top Products
TM
Assembly
Steering
Bushing
Steering
Bushing
Vehicle
Frame
Neck
• Position the vehicle frame so that the front faces you.
• Fit a steering bushing on the neck of the vehicle frame.
• Fit the other steering bushing under the neck.
• Insert two screws through the side of each steering
bushing and into the neck.
• Tighten all four screws using a Phillips screwdriver.
Do not over-tighten.
• Lift the pretend buckles on a saddle bag to open the
saddle bag.
• Fit the tab on the back surface of the saddle bag into the
notch on one side of the rear fender.
• Insert three screws through the holes on the inside of
the saddle bag.
Note! The lower screw travels through holes in the saddle
bag and vehicle body, and screws into the vehicle frame.
Make sure all the screw holes are aligned.
• Tighten the screws using a Phillips screwdriver. Do not
over-tighten.
• Repeat this step to assemble the other saddle bag to the
other side of the vehicle.
16
Saddle
Bag
Tab
Notch
17
Rear View
.437 (Large
Diameter)
Retainer
Tube
Side
Wheel
Axle
15
• Slide an axle bushing (tube side first) onto the end of
the wheel axle. Make sure the flat end of the axle
bushing fits into the groove in the fork arm.
• Fit a .437 (large diameter) retainer on the end of
the axle.
• Support the opposite end of the axle and tap the
.437 retainer with a hammer to secure it on the end of
the rear axle.
• Pull on the .437 retainer to make sure the rear wheel
assembly is secure.
Rear View
Axle
Bushing
13
Axle
Bushing
Vehicle
Frame
Rear
Fork
Arm
Groove
Rear
Fork
Arm
Wheel (with
Hex Busings)
14
• Position the vehicle so that the back is facing you.
• While holding the hex bushings in place, position the
wheel between the rear fork arms of the vehicle frame.
• Slide the wheel axle (with axle bushing) through one
rear fork arm, through the wheel (with hex bushings)
and out through the other rear fork arm. Make sure the
axle bushing fits into the groove in the fork arm.
Rear View