Filter
Top Products
TM
Assembly
TM
TM
10
1
2
• Pull firmly to separate the two black motor harness
connectors near the rear of the vehicle frame.
• Position the vehicle body on top of the vehicle frame.
• Fit each motor harness connector up through the
rectangular opening in the vehicle body, one at a time.
• Fit the two halves of the high speed hook-up connector
through the square opening near the front of the
vehicle body.
• Insert four screws through the vehicle body and into the
vehicle frame. Make sure the holes in the vehicle body
and frame are aligned.
• Tighten the screws using a Phillips screwdriver.
Do not over-tighten.
4
Square
Opening
Motor
Harness
Connectors
Vehicle
Frame
Vehicle
Body
Rectangular
Opening
High Speed
Hook-Up
Vehicle
Frame
Vehicle
Body
F
• Fit the motor harness wires through the retainer tabs so
that all four motor harness wires are contained in the
narrow rectangular opening.
• Fit the tabs on the top of one motor harness connector
into the slots in the bottom of the other motor harness
connector and squeeze firmly to re-join the two motor
harness connectors (see inset).
Motor Harness
Connectors
Narrow
Rectangular
Opening
3
Motor Harness
Connectors
Retainer
Tabs
Top View
• Fit the tabs on the left footboard into the slots in the left
side of the vehicle frame. Make sure both tabs are in
the slots.
Helpful Hint! You may need to squeeze the left footboard
in order to align the tabs with the slots.
• Insert two screws into the left footboard as shown.
• Tighten the screws using a Phillip screwdriver. Do not
over-tighten.
Left
Footboard
Tab
Tab
Slots