Filter
Top Products
Page 5SKU 98135 For technical questions, please call 1-800-444-3353.
INITIAL SET UP
INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section
at the beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Turn the Power Switch of the
pump to its “OFF” position
and disconnect from power
source before assembling or
making any adjustments to
the pump.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Assembly
Note: Use a gasoline- and oil-proof
pipe compound (not supplied) on
all joints.
Thread male end of Steel Elbow (39) 1.
into the Pump Housing (1). Tighten
securely at this point.
Thread end of Hose (55) into female 2.
end of Steel Elbow (39). DO NOT
tighten securely.
Thread Nozzle (54) to Hose (55). DO 3.
NOT tighten securely.
After making sure connections will 4.
and three until after Fuel Transfer
Pump has been installed on tank,
barrel, or drum. When installed, at-
tach parts as in steps two and three.
Wrench tighten all connections.5.
Functions
This Fuel Transfer Pump is com-1.
patible and may be used with the
following uids: Diesel, Kerosene,
light weight oils, water and anti-
freeze. This Pump IS NOT compat-
ible with, and should NEVER be
used to pump: Acetone, Gasoline,
Ammonia, Lacquer Thinner, Ben-
zene, Bleach, Hydrochloric Acid, Ink
or Toluene. NOTE: No other uids
should be used, but the “incom-
patible” uids listed above can be
especially dangerous. Not for use
with uids that have a ashpoint
below 100°F/38°C.
2.
with this Pump (except for diesel
General Installation and
Connection Instructions
Keep work area clean and well lit. 1.
Cluttered or dark areas invite acci-
dents.
Use safety equipment. Always 2.
wear ANSI-approved safety gog-
gles. Safety equipment such as
dust mask/respirator (for fumes),
and non-skid safety shoes.
This Fuel Transfer Pump has a built-3.
in Check Valve Assembly (27) with
-
mal expansion from causing unsafe
REV 08h