Filter
Top Products
Page 4SKU 96933 For technical questions, please call 1-800-444-3353.
SPECIFICATIONS
Electrical Requirements 12 V / 4.3 A
Bulb Type 12 V / 21/5 W
Connector 4-way Flat
WIRING
Note: Some towing vehicles may already have a 4-way Flat Connector, “Trunk” plug
wired in. For those vehicles, skip the following wiring instructions.
If you do not have experience
doing this type of automotive
electrical wiring or if the
wiring in your vehicle differs
from that explained below,
have an automotive service
technician connect the wiring.
Identify the towing vehicle’s wires
in the trunk that correspond to
the circuits indicated in the Wiring
Color Code diagram to the right.
The white ground wire from the
Pigtail (22) may be connected to a
bolt or appropriate component on
the vehicle to establish a ground
instead of a ground wire.
Connect the wires from the Wiring Pigtail (22) to the proper vehicle circuit wires
using Wire Splices (21). No stripping or cutting is usually required to connect
wires using the included Splices. Follow these three steps and refer to the
illustration to the right:
Insert the end of the Pigtail (22)
wire into the ‘dead-end’ channel
of the Splice. Insert the wire all
the way to the end of the chan-
nel as shown.
Place the Splice around the
correct vehicle circuit wire.
Make sure both wires stay
properly in place while the
cover is closed until it snaps
together.
Verify that all wires are held se-
curely.
1.
2.
a.
b.
c.
3.
Wiring Color Code
Note: This is the wiring conguration of the
“Trunk” 4-way Flat Connector (23). The
towing vehicle may have a different wir-
ing color code.
WHITE
Ground
BROWN
Running Lights
YELLOW
Left Stop and
Turn Lights
GREEN
Right Stop and
Turn Lights
“Trunk” 4-way Flat
Connector (23)
Wiring
Pigtail (22)
Wiring Color Code
Note: This is the wiring conguration of the
“Trunk” 4-way Flat Connector (23). The
towing vehicle may have a different wir-
ing color code.
WHITE
Ground
BROWN
Running Lights
YELLOW
Left Stop and
Turn Lights
GREEN
Right Stop and
Turn Lights
“Trunk” 4-way Flat
Connector (23)
Wiring
Pigtail (22)
Wire Splice (21) Usage
B) Place splice around
vehicle wire
C) Close Splice
cover securely
A) Insert Pigtail (22) wire
into ‘dead-end’ channel
Wire Splice (21) Usage
B) Place splice around
vehicle wire
C) Close Splice
cover securely
A) Insert Pigtail (22) wire
into ‘dead-end’ channel