Filter
Top Products
SKU 95621 Page 3
6. Use the right tool for the job. Do not attempt to force a small tool or
attachment to do the work of a larger industrial tool. There are certain
applications for which this tool was designed. Do not modify this tool and do
not use this tool for a purpose for which it was not intended.
7. Dress properly. Do not wear loose clothing or jewelry as they can be
caught in moving parts. Protective, electrically non-conductive clothes and
non-skid footwear are recommended when working. Wear restrictive hair
covering to contain long hair.
8. Use eye and ear protection. Always wear ANSI-approved impact safety
goggles. Wear a full face shield if you are producing metal filings or wood
chips. Wear an ANSI-approved dust mask or respirator when working around
metal, wood, and chemical dusts and mists.
9. Do not overreach. Keep proper footing and balance at all times. Do not
reach over or across running machines.
10. Do not use Roller Stand to support people or animals.
11. Stay alert. Watch what you are doing, use common sense. Do not operate
any tool when you are tired.
12. Take caution as some woods contain preservatives such as copper
chromium arsenate (CCA) which can be toxic. When cutting these
materials care should be taken to avoid inhalation and minimize skin contact.
13. Check for damaged parts. Before using any tool, any part that appears
damaged should be carefully checked to determine that it will operate
properly and perform its intended function. Any part that is damaged should
be properly repaired or replaced by a qualified technician.
14. Replacement parts and accessories. When servicing, use only identical
replacement parts. Use of any other parts will void the warranty.
15. Do not operate tool if under the influence of alcohol or drugs. Read
warning labels on prescriptions to determine if your judgment or reflexes are
impaired while taking drugs. If there is any doubt, do not operate the tool.
16. Maintenance. For your safety, periodically check hardware for tightness.
17. Do not exceed the Roller Stand’s maximum weight capacity of 132 lbs.
18. Only use the Roller Stand on a flat and level surface capable of
supporting the weight of the Stand and the weight the workpiece.
Warning: The warnings, cautions, and instructions discussed in this instruction
manual cannot cover all possible conditions and situations that may occur. It
must be understood by the operator that common sense and caution are factors
which cannot be built into this product, but must be supplied by the operator.