Filter
Top Products
SKU 95058 For technical questions, please call 1-800-444-3353 Page 6
Installation
WARNING: Before Installation, disconnect negative then positive battery cables in that order.
WARNING: Whenever drilling, be sure that drill will not damage any wires, tubes or components
on either side of the member being drilled. Plan for your installation so units will be located con-
veniently and wires will be routed out of the way of any other components. Plan to fill all drilled
holes with sealant to prevent water intrusion or rust.
Light Installation: Drill hole in front bumper to install light, (make sure there are no
hidden wires in the drilling path). Fasten Light unit with nut and bolt. Adjust angle of
lamp as desired. Connect the ground wire from the lamp to a clean grounded piece of
metal on the vehicle frame.
Install the as shown in the Installation Diagram on page 7. Attach one appropriately-sized
red wire from fuse to the positive (red) battery cable. Connect another wire from the fuse to
the positive terminal on the switch. Carefully route two more wires from the other positive
terminal on the switch to the ballasts.
WARNING: Do not damage any cables, hoses or components when installing any com-
ponent of this kit. Take care not to route wires where they may get tangled, pinched, cut,
burned or otherwise damaged by the operation of the engine or movement of the car.
Install Ballasts near lights. Connect lights to ballasts using the wire plugs. Connect positive
wires from the light switches to the ballasts. See Installation Diagram on page 7.
CAUTION: Do not reverse polarity, as that will damage unit.
Reconnect the vehicle positive battery cable. Test lights.
Be sure the Fog Lights, Ballasts and Switch are firmly attached and will not come loose
during normal driving or a sudden stop.
Periodically check the Fog Lights and Ballasts to be sure they remain in place. Make any
adjustments as needed.
1.
2.
3.
4.
5.
6.
7.
8.
Single Light Installation Diagram
Ballast
Fog Light
Fog Light Connectors
to Switch
to Ground