Harbor Freight Tools 67498 Automobile Accessories User Manual


  Open as PDF
of 8
 
Page 5For technical questions, please call 1-800-444-3353.SKU 67498
shown on the manual cover, with the extra
section over the truck cab. If assembling in

and go to “Completing the Rack” below. If
assembling with the over-cab section, attach

the assembled rail sections using the same
hardware as used for attaching the other side
rail sections.
Note: The Rack supports up to 1500 lbs in the


Completing the Rack
Working with one assembled section, 1.


over-cab construction also slide the front

and tighten in place with the Hex Bolts

Slide the other ends of the Crossbars 2.
into the other assembled section, insert
the Hex Bolts, but do not fully tighten so
you can adjust the width of the Rack, if
needed.
Note:


the J-Bolt Slots in the Post bases.
Note: If attaching to a truck bed with a liner,
use a 


truck bed and liner.
Attaching the Rack to the Truck
With a helper, lift the assembled Rack 1.
and position on the vehicle.
2.
needed.
If using the J-Bolts, hook them under 3.
the Pickup Side Rim. Adjust the width
or post positions as needed until the
Rack is ready to secure. Secure in place
through the base of the Posts with the


as needed for your vehicle.
Adjust and tighten the Hex Bolts 4.
holding the Crossbars. Check that all
connections are secure and all bolts are
tight.
Insert the Large and Small End Caps 5.

posts.
Note: You may want to shorten the length of
the Back Rails by sawing off the ends
before inserting the End Caps.
OPERATION
Secure all loads in place.1.
Be aware of dynamic loading. Dropping, 2.

create excess load causing product
failure.
Cargo protruding beyond the back of the 3.


Check local DOT regulations.
 previous next