Page 3For technical questions, please call 1-800-444-3353.SKU 67498
ASSEMBLY INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
document including all text under
subheadings therein before set up
or use of this product.
Figure 1
Assembled Rail
or short bed pickup truck, with or without the
section over the vehicle cab. You can adjust
the location of the Posts along the Assembled
J-Bolt Conguration
J-Bolt Slot
Post Base
Side of Pickup Bed
Pickup Side Rim
Figure 2
shown in Figure 2 for bolting the Rack
to the truck bed without drilling holes
through the top of the rim. You will need
to cut holes in the side of a liner if the
truck bed has a liner, or if the side of the
truck bed is solid, without an inner rim.
Drilled and Bolted Conguration
Figure 3
Bed Liner
Holes drilled in
Bed Liner
To mount the Rack by bolting it to the
top of the truck bed rim, you will need
to drill holes in the top of the Pickup rim
bed has a liner, or the side of the truck
bed is solid, you will also need to cut 2”
holes in the side so you have access to
CAUTION: Do not drill any holes until you
have fully assembled the rack and
placed it on the truck bed to double
check the hole placement.
Preparation
Lay out and identify all parts. 1.
Note: Some parts are similar, but not
identify all parts.
Determine approximately where to 2.
the truck bed without interfering with
other structures or hidden components
within the truck bed. Record the distance