Filter
Top Products
PAGE 4 OF 13
BU303-353_WIN_UsersGuide_ v2.3
USB GPS (WIN)
From within your mapping, or navigation software (including the supplied GPS Information utility), you
will need to manually configure the selection of the COM port to what was assigned to the GPS
receiver so that proper communication between the GPS receiver and mapping program can occur.
Most all software requires that you manually configure the COM port setting for any GPS device you
use.
IMPORTANT:
1. You must change the default rate setting of your mapping software ‘s Baud Rate to 4800 if this is not currently
set as such otherwise GPS data cannot be received.
2. Set Baud Rate 4800, Data Bit: 8, Parity: None, Stop Bit: 1, Flow Control: None