Filter
Top Products
Black plate (8,1)
Cadillac CTS/CTS-V Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-
6014443) - 2014 - CRC - 4/3/13
2-8 Keys, Doors, and Windows
5. The DIC displays PRESS
START CONTROL TO
LEARN KEYS.
6. Press the ignition switch in.
7. The DIC reads LEARN DELAY
ACTIVE WAIT XX MIN and
counts down to zero.
8. The DIC displays PRESS
START CONTROL TO LEARN
KEYS again.
9. Press the ignition switch in
again.
10. Repeat Steps 7, 8, and 9.
11. The DIC reads LEARN DELAY
ACTIVE WAIT XX MIN and
counts down to zero.
12. A beep sounds and the DIC
reads READY TO LEARN
ELECTRONIC KEY # X. All
previously known transmitter
programming has been erased.
13. A beep sounds once
programming is complete.
The DIC displays READY
TO LEARN ELECTRONIC
KEY # 2.
To program additional
transmitters, insert each
transmitter in the pocket
until a beep is heard and the
DIC advances to the next
electronic key number. Up to
eight transmitters can be
programmed. The DIC displays
MAXIMUM # ELECTRONIC
KEYS LEARNED and exits the
programming mode.
14. Press the ignition control knob
if programming is complete.
15. Press
K on each newly
programmed transmitter to
complete the process.
Starting the Vehicle with a Low
Transmitter Battery
Replace the battery if the REPLACE
BATTERY IN REMOTE KEY
message displays in the DIC. See
“Replace Battery In Remote Key”
under Key and Lock Messages on
page 5-37 for additional information.
If the transmitter battery is weak, the
DIC may display ELECTRONIC
KEY NOT DETECTED when you try
to start the vehicle. To start the
vehicle, place the transmitter in
the center console storage area
transmitter pocket with the buttons
facing to the front of the vehicle.
Then, with the vehicle in P (Park) or
N (Neutral), press the brake pedal
and the ignition control knob. See
Starting the Engine on page 9-20,
for additional information about the
vehicle's electronic keyless ignition.
Replace the transmitter battery as
soon as possible.