Filter
Top Products
There are several conditions that can cause this
message to appear.
.
One condition is overheating, which could occur if
StabiliTrak activates continuously for an extended
period of time.
.
The message also displays if the brake system
warning light is on. See Brake System Warning
Light on page 4‑36.
.
The message could display if the stability system
takes longer than usual to complete its diagnostic
checks due to driving conditions.
.
The message displays if an engine or vehicle
related problem has been detected and the vehicle
needs service. See your dealer.
.
The message also displays if the vehicle is shifted
into 4LO (Two Speed Transfer Case Only).
The message turns off as soon as the conditions that
caused the message to be displayed are no longer
present.
TIGHTEN GAS CAP
This message may display along with the check engine
light on the instrument panel cluster if the vehicle's fuel
cap is not tightened properly. See Malfunction Indicator
Lamp
on page 4‑39
. Reinstall the fuel cap fully.
See Filling the Tank
on page 6‑11
. The diagnostic
system can determine if the fuel cap has been left off or
improperly installed. A loose or missing fuel cap allows
fuel to evaporate into the atmosphere. A few driving
trips with the cap properly installed should turn this light
and message off.
TIRE LEARNING ACTIVE
On vehicles with the Tire Pressure Monitor System
(TPMS), this message displays when the TPMS is
re-learning the tire positions on your vehicle. The tire
positions must be re-learned after rotating the tires or
after replacing a tire or sensor. See Tire Inspection and
Rotation
on page 6‑78
, Tire Pressure Monitor System
on page 6‑73
, and Inflation - Tire Pressure
on
page 6‑72
for more information.
4-69