Filter
Top Products
3-6
PASSENGER Control: The PASSENGER CONTROL
buttons with the arrows adjust the temperature on the
passenger’s side so it is warmer or cooler than the
temperature for the driver’s side. Push the DUAL button
so that the indicator light is lit. Press the right arrow
button to raise the temperature. Press the left arrow
button to lower the temperature.
The display will not show the passenger’s temperature,
only that of the driver. Indicators in the passenger
control section will show passenger’s side temperature
relative to the driver’s set temperature.
The amber light indicates the same temperature as
set for the driver.
The red lights indicate a warmer temperature than
that of the driver.
The blue lights indicate a cooler temperature than
that of the driver.
AUTO (Automatic Control): For the most efficient
operation, you should set the system temperature and
press AUTO. The system will then select the best fan
speed and airflow settings to keep you comfortable. The
air conditioning compressor will run if the outside
temperature is above 40 F (4 C). You may notice a
delay of two to three minutes before the fan comes on at
start up in cool weather.
For the automatic system to function, the temperature
must be set between 61 F (16 C) and 89 F (31 C).
The driver’s temperature and passenger’s temperature
settings will be automatically maintained even if manual
overrides have been selected except for settings at
60 F (15 C) and 90 F (32 C).
Setting the temperature to 90 F (32 C) will lock
control in full hot, direct air to the floor, and increase
the fan speed to high. The system will not return to
automatic temperature control until the temperature
setting is lowered.
Setting the temperature to 60 F (15 C) will lock
control in full cold, recirculate interior air, direct air
to outlets on panel and increase blower speed to high.
The system will not return to automatic temperature
control until the temperature setting is raised.
OFF: Press this button to turn the air compressor off.
Heating
On cold days, use HTR with the driver and passenger
levers all the way in the red area. This system will bring
in outside air, heat it, and send it to the floor ducts.