Filter
Top Products
14
Quick Reference Guide
FUNCTIONS OPERATIONS
Sending
an SOS
Press and hold the SOS Button for a minimum of 4 seconds. The Signal
light will be green while the unit reports the emergency to the control
panel and to the speed dial numbers that you set.
Location
Request—
from a phone
Mobile phone numbers that have been preset and stored in Speed
Dial Buttons 1 and 2 can call and request location information from
the unit. The Gemini recognizes these numbers and automatically
hangs up after one ring. The location of the Gemini will then be sent
to the phone that requested the location.
Activating
Geofence
Press “G” Button for 4 seconds, the unit will beep once and report to
the control center and automatically activate the Geofence function.
You can also set and define Geofence boundaries by logging on to
your account at www.geminitracking.com.
Deactivating
Geofence
Press “G” Button for 4 seconds, the unit beeps twice and deactivates
the Geofence. You can also deactivate the Geofence by logging on to
your account at www.geminitracking.com.
Answering
Call
Any phone can be used to call the unit, and the unit will notify the user
with music ring. To answer the call, simply press the “Answer” Button.
Ending Call User can end the call by pressing the “Hang-up” Button.
Calling out Users can call any preset number (1, 2, 3) by simply pressing the
appropriate Speed Dial Button.
Volume
Control
Press “Volume/Test” Button to adjust sound level during a phone call.
(Volume adjustment sequence: Medium
→ High → Low)
GSM/GPS Test Press “Volume/Test” Button to test for GSM (cellular) and GPS
reception while in normal standby mode. Green light stays on for 4
seconds if GSM (cellular) signal is OK (no green light if no GSM signal)
Blue light stays on for 4 seconds if GPS signal is OK (if no GPS signal.
then signal light blinks blue for 20 seconds).
Hands-free Earphone is included for user to answer the phone hands-free.
Worldwide
monitoring
and tracking
With the European GSM communication module, to use worldwide
without distance restrictions
Low battery Signal light is red and says on. A message is sent to the control panel
that the unit needs to be charged.
Charging Signal light is orange and stays on when the unit is charging while in
the “Off” position, and goes out if the unit is fully charged.
Car/Home
charger
Using DC 12V charger (for car) and AC 110V–240V charger (for home)
to charge the unit.
User Manual.indd 14 2/2/06 10:27:54 AM