Filter
Top Products
www.garrett.com
8
Master Hunter
®
CX Plus Owner’s Manual
9
ASSEMBLY
No tools are required to assemble the Master Hunter
CX Plus. Hand tighten all necessary parts.
1. Compress the button end of the spring clip and
insert, button end rst into the lower stem of your
detector so that the buttons pop out of the holes as
they do in the upper stem. These two sets of buttons
will enable you to secure the top stem to the control
housing and to adjust the length of the overall stem
to your height so that you can scan with the detector
comfortably.
2. Attach the lower stem to the searchcoil. Make
certain that two rubber washers are inserted into this
stem before slipping the searchcoil onto it. Place the
threaded bolt through the holes in the connector and
hand tighten the knobs. No tools are needed.
3. Depress buttons in the upper stem and slide into
the control housing until they pop into the holes.
4. Depress the buttons in the lower stem and insert it
into the upper stem. Buttons will pop into the holes
and you can achieve the desired stem length. The
third set of holes from the end is most commonly
used.