nüvi 5000 Owner’s Manual 25
UsingFMTrafc
Using FM Trafc
Use an FM TMC (Trafc Message
Channel) trafc receiver to receive
trafc information broadcast over the
FM Radio Data System. For information
about FM trafc receivers and coverage
areas, see www.garmin.com/trafc.
NOTE: Garmin is not responsible for
the accuracy of the trafc information.
The FM trafc receiver receives
signals from the trafc service
provider and shows that information
on your nüvi.
NOTE: The FM trafc receiver and
nüvi must be in data range of an FM
station transmitting TMC data to
receive trafc information.
NOTE: The nüvi must be connected
to the optional FM trafc receiver to
access trafc information.
NOTE: If your FM TMC trafc
receiver has an antenna with suction
cups on it, route the antenna on your
windshield vertically using the suction
cups.
LED Blink Codes
The green Power LED lights when
connected to external power. The Status
LED indicates the signal reception:
Yellow dot-dash ashes: determining
which country you are currently in.
Yellow solid: searching for signal.
Red solid: momentary sync loss.
Green solid: normal trafc data.
•
•
•
•
To the power outlet
in the vehicle
To the power
connector on the
nüvi cradle
Power
LED
Status
LED