Garmin 5000 GPS Receiver User Manual


 
2 nüvi 5000 Owner’s Manual
Getting Started
Step 1: Mount the nüvi
To mount the nüvi using the suction
cup mount:
1. Plug the vehicle power cable into the
power connector on the right side of
the cradle.
2. Clean and dry your windshield with
a lint-free cloth. Remove the clear
plastic from the suction cup. Place
the suction cup on the windshield.
3. Flip the lever back, toward the
windshield.
4. Snap the cradle onto the suction cup
arm.
5. Fit the bottom of your nüvi into the
cradle.
6. Tilt the nüvi back until it snaps into
place.
7. Plug the other end of the vehicle
power cable into a power outlet in
your vehicle. Your unit should turn
on automatically if it is plugged in
and the vehicle key is turned to the
ON/ACC position.
8. Ifyouareusingatrafcreceiverin
Europe,securethetrafcreceiver’s
antenna to the windshield using the
suction cups.
To mount the nüvi using the
dashboard mount:
Use the enclosed mounting disk to
mount your unit to the dashboard and
comply with certain state regulations.
Cradle
Power cable
Suction cup mount