Garmin GPS Receiver GPS Receiver User Manual


 
2 Garmin Mobile
for BlackBerry
®
set up and go!
Locate the metal contacts on the end of the
lithium-ion battery. Insert the battery so the metal
contacts on the battery match up with the metal
contacts inside the battery compartment. Press the
battery down into place.
Replace the battery cover by inserting the tabs into
the notches. Press the battery cover closed; the
release tab locks the cover in place.
Battery
cover
Release tab
Lithium-ion
battery
Replacement Battery
If you need to replace the battery, use a Garmin 3.7
Volt lithium-ion battery pack (010-10840-00). Purchase
a replacement battery at http://my.garmin.com/shop.
You can also use a compatible cell phone battery, such
as a Nokia BL-5C.
4.
5.
➌
Charge the GPS 10x Receiver
Plug the small end of the power cable into the
mini-USB connector on the end of the GPS 10x.
Plug the other end of the power cable into an
available power outlet in your vehicle.
You can use the GPS 10x receiver while you are
charging it. It takes about four hours to charge the
battery. A fully charged battery lasts about 22 hours.
➍
Turn On the GPS 10x Receiver
To turn on the GPS 10x receiver, press and hold the
Power button on the top of the GPS 10x receiver.
Bluetooth LED Status
Rapid Flashing Blue: power on, Bluetooth on
Slow Flashing Blue: Bluetooth link to your
BlackBerry device established
Power LED Status
Flashing Yellow Green: charging in progress
Solid Yellow Green: battery is charged
Flashing Orange: low battery
Solid Orange: faulty battery or system error
1.
2.