Filter
Top Products
60 nüvi 3700 Series Owner’s Manual
Appendix
3. Install a 2 A fast-blow fuse.
4. Verify that the silver tip is located
in the end piece.
Using a coin, replace the end
piece.
Mounting on Your
Dashboard
Notice
The permanent mounting adhesive is
extremely difcult to remove after it
is installed.
Use the enclosed mounting disk to
mount your device to the dashboard
and comply with certain state
regulations.
1. Clean and dry the dashboard
where you are placing the disk.
2. Remove the backing from the
adhesive on the bottom of the
disk.
3. Place the disk on the dashboard.
4. Remove the clear plastic cover
from the top of the disk.
5. Place the suction cup mount on
top of the disk.
6. Flip the lever down (toward the
disk).
Removing the Device,
Cradle, and Mount
Removing the Device from
the Cradle
1. Press up on the tab on the top of
the cradle.
2. Tilt the device forward.
Removing the Cradle from
the Mount
1. Turn the cradle to the right or
left.
2. Apply pressure until the socket
on the cradle releases the ball on
the mount.