Filter
Top Products
1414
1515
Dashboard Installation
CAUTION! : The rear of the unit must be supported to prevent damage to the dash and/or
improper operation due to vibration.
NOTE:
• This unit is carefully designed to protect & minimise the temperature of your iPod
during use. An internal fan will operate automatically when an iPod is connected,
• For installation, please ensure rear Fan vent holes are not obstructed & adequate
clearance is available to allow free air flow.
AUX OPERATION
Aux Connect
Connect an audio source to the AUX cable in the rear panel.
Aux Mode Selection
Press the SOURCE button to select AUX mode.
Radio - iPod - AUX
INSTALLATION GUIDE
1. Disconnect the negative (-12 V) lead from your battery to avoid potential damage to
the unit.
2. Remove the detachable front panel and slide the mounting sleeve off the chassis using
the removal keys provided.
3. Insert the mounting sleeve into the mounting hole and bend the locating tabs out to
secure the sleeve into the dash.
4. Ensure you follow the wiring Table (see page 17). Incorrect connections may cause
damage to the unit and the vehicle’s electrical system. (and is not covered under
warranty)
5. After all wiring connections are completed attach the front panel to confirm operation.
6. Slide the unit into the mounting sleeve ensuring it locks into place and attach the
perforated support strap (supplied ) to the screw stud on the rear of the chassis using
the hex nut provided. Fasten the opposite end of the strap to a secure location.
Additional Functions
Additional functions avaliable while the iPod is playing
Intro Scan - Shuffle - Repeat Track - Repeat Folder
To activate additional functions when the iPod is playing;
- Press and hold the joystick and the iPod FUNCTIONS screen will appear
- Select a function by using the joystick encoder, confirm your selection by pressing the
joystick
CA-IP500 Manual ENGLISH v3.indd 14-15CA-IP500 Manual ENGLISH v3.indd 14-15 25/11/08 9:06:51 AM25/11/08 9:06:51 AM